Teledyne-lecroy PCIe Gen3 M.2 Interposer Quick Start Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Ekwipunek Teledyne-lecroy PCIe Gen3 M.2 Interposer Quick Start. Teledyne LeCroy PCIe Gen3 M.2 Interposer Quick Start User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 8
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
Gen3 M.2 Interposers
Quick Start for Summit™
Analyzers
Before Starting
Use this document for quick installation and
setup. If you experience problems or need more
information, see the product manuals available at
the Teledyne LeCroy web site or in the
Documents folder in the PETracer installation
CD.
1
Introduction
The Teledyne LeCroy PCIe 3.0 M.2 Interposer, which is used with Summit™ Protocol Analyzers,
enables PCIe
®
bus traffic between a system board or tablet and a M.2/NGFF connector on a PCIe
M.2 device to be monitored, captured, and recorded for protocol analysis. The M.2 interposer will
support analysis for PCIe host interfaces such as SATA Express (AHCI/PCIe) and NVM Express
(NVMe) at data rates from 2.5 GT/s up to 8 GT/s, and lane widths of up to x2 or up to x4 depending on
the key type.
Przeglądanie stron 0
1 2 3 4 5 6 7 8

Podsumowanie treści

Strona 1 - Analyzers

Gen3 M.2 InterposersQuick Start for Summit™ AnalyzersBefore StartingUse this document for quick installation and setup. If you experience problems or

Strona 2 - Components

2ComponentsThe Teledyne LeCroy Gen3 M.2 Interposer kit has the following components:• M.2 Interposer with Carrier board• Connector cable assembly 18 i

Strona 3 - Interposer Cable Assembly

3Interposer Cable AssemblyThe Extension brackets are provided to allow the user to attach and secure the Teledyne LeCroy M.2 interposer cable on the h

Strona 4

This procedure describes the assembly process for the Type 2260 bracket (to install the other types follow the same procedure):1. Place the Extension

Strona 5 - Installed

Exploded ViewInstalled Side ProfileInstalled

Strona 6 - Hardware Installation

Hardware InstallationTo use this interposer:1. Set the SW1 DIP switches to the desired clock selection.Note: "HOST_CLK" should be the d

Strona 7 - Software Configuration

6Software ConfigurationThe default configuration of the Gen3 M.2 Interposer is the (x4 width) configuration. To set Recording Options: 1. Open the PET

Strona 8 - Recording Traffic

Trademarks and ServicemarksTeledyne LeCroy, PETracer and Summit are trademarks of Teledyne LeCroy. All other trademarks are property of their respecti

Komentarze do niniejszej Instrukcji

Brak uwag